Dfreeeze parking heater remote control Guía de instalación descargar pdf (Pagina 32)

Preparation of the adapter cable

To make the adapter cable as universally applicable as

possible, not all lines are connected in the delivery state.

Depending on the installation conguration, you must

therefore prepare your cable accordingly.

Insertion of contact pins into the housing

Concerns: Installationconguration1-2;4-7

When plugging in the contact pins, note the following

general information:

● Remove the transport lock and pull the

insulating sleeve from the contacts.

● Notethecorrectpinassignment;thechambers

are numbered on the plug housing

Youcanndtherespectivepinassignmentin

the detailed description on the following pages-

● Note the tongue on the plug contact as well

as the associated guide groove on the plug

housing.

● Ensure that the plug contact is completely

seated in the housing.

● Do not attempt to insert the plug contact into

the plug housing with force.

Connection with the W-bus cable (yellow)

Concerns: Installationconguration1-3

To connect the yellow W-bus cable between plug X2 and

X3:

● Pull both yellow cable ends out of the middle

bundling

● Pull the insulation off of the cable

● First insert one cable end and then the other

end of the cable into the accompanying butt

connector and crimp both sides successively

with suitable pliers.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Sin comentarios

Dfreeeze parking heater remote control Guía de instalación Pagina 32