Dfreeeze parking heater remote control Guía de instalación descargar pdf (Pagina 38)

*The information refers to the signals on the dfreeeze

receiver (plug X3).

If no feedback signal to pin 4 on plug X3 is

present, the proper function of the dfreeeze

cannot be guaranteed.

Preparation of the adapter cable

● To connect an original VW parking heater, the

plugs X1 and X2 must be replaced with the

blue VW plugs.

● Connect the plugs X1 and X3 as shown in the

cable diagram on the right.

Note the information on page 32 when

preparing the cable.

Connecting the dfreeeze

receiver

● Connect the plug connector with the respective

devices as shown in the system diagram to the

right.

Installation con guration 4 & 5

The installation congurations 4 & 5 describe the

connection of the dfreeeze

receiver to an original VW

parking heater (installed ex works or retrotted as an

original accessory).

Installation con guration 4: Telestart VW MQB

Vehicles based on MQB (e.g. VW Golf VII,

Skoda Oktavia III)

Switching output - Pin 3* 12V continuous signal

Switching input - Pin 4* 12V continuous signal

(for response)

Installation con guration 5: Telestart VW PQ

Vehicles based on the PQ-platform (e.g. VW Golf VI,

VW Touran)

Switching output - Pin 3* 12V switching impulse

Switching input - Pin 4* 12V continuous signal

(for response)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Sin comentarios

Dfreeeze parking heater remote control Guía de instalación Pagina 38